check out the new remote control Jockey Wheel SmartBar rearview170 Beam Communications SatPhone Shop Topargee products Enginesaver Low Water Alarms
Members Login
Username 
 
Password 
    Remember Me  
Post Info TOPIC: Under bed Air conditioners - reviews sought


Veteran Member

Status: Offline
Posts: 29
Date:
Under bed Air conditioners - reviews sought


I need to buy an A/C for my new pop top slide on.

There are three main products I see here in Australia:

  • Truma Saphir
  • Haughton Belaire HB9000, and
  • Denso UB1.

All are 'do-it-yourself'  plug and play simple boxes and all similar size, capacity, rating etc. The obvious differences are hose outlets options.

I will be buying one of them, but am not sure which, yet.

I'm looking to hear from owners who have tried any of these, to see if any advantages disadvantages.



__________________


Senior Member

Status: Offline
Posts: 430
Date:

I had the Truma Saphir on my van. Good little unit, heated and cooled, was just strapped down to the floor so easy to remove if I was going off-grid so couldn't use it and wanted to use the weight allowance for extra water/food instead. It requires three holes in the floor of the van, two large ones for the air intake and outlet, and a small one for the condensate drain. I would happily have one again, and definitely in preference to a roof-top one on a pop-top. Can't compare it to the other two you mention as I have no experience of them.

__________________


Guru

Status: Offline
Posts: 2046
Date:

Hi Jason,
My van has a Heron permanently built in so it's not the same as what you're looking for.
As Mamil said, you don't have to be superman to lift the "lid" - an extra 7+kg up there would make it difficult.

Externally it's noisy but with it under my bed, it's ok. Mine has the air inlet coming in through the side with the outlet holes in the floor in front of the wheel. Performance wise, it heats & cools well. I've heard somewhere along the track that rooftops don't heat up in cold temps, mine never misses a beat.

How the portables work, I don't know but I've seen entries on this forum of how to make a semi-permanent installation of one.
Your weights should be a big consideration.

__________________

Warren

----------------

If you don't get it done today, there's always tomorrow!

2019 Isuzu D-Max dual cab, canopy, Fulcrum suspension; 2011 17' Jayco Discovery poptop Outback



Veteran Member

Status: Offline
Posts: 29
Date:

Thanks everyone.

__________________


Guru

Status: Offline
Posts: 1266
Date:

We had our air con under the bed at the foot of it we cut the square frame work under the bed to fit it and it
Worked brilliant all except it made the floor cold so we got a piece of cardboard the length of the air con and bent it so the air went upwards we also put a fan that clips onto a cupboard which blew it around the room
The air con itself was brilliant couldnt hear it running ,the motor was on the back of the van. We ran it on lithium set up of batteries by terry from T1terry mannum. I cant take photos as ive split up from mr glassies
(Graeme) and the van was a write off in a hail storm so its gone now too . Hope this helps

__________________

glassies



Veteran Member

Status: Offline
Posts: 58
Date:

has anyone used a furrion 9000 , they seem to be the best priced but I cant any reviews/info about them

thanks



__________________


Veteran Member

Status: Offline
Posts: 58
Date:

has anyone used a furrion 9000 , they seem to be the best priced but I cant any reviews/info about them

thanks



__________________


Guru

Status: Offline
Posts: 7579
Date:

A number of people here have installed a 2.5kW a Mitsubishi split system in their caravan. The 2.5kW air conditioners (pretty much any top end manufacturer) are the ants pants for efficiency. 

 

You can run them off batteries for extended time, if a bit of forethought goes into the set-up. Cost wise it's a no brainer.

 

 



__________________

Procrastination, mankind's greatest labour saving device!

50L custom fuel rack 6x20W 100/20mppt 4x26Ah gel 28L super insulated fridge TPMS 3 ARB compressors heatsink fan cooled 4L tank aftercooler Air/water OCD cleaning 4 stage car acoustic insulation.



Senior Member

Status: Offline
Posts: 311
Date:

That is Mitsubishi Heavy Industries.

I am planning around a 2kw one for the new OKA, to run from solar/batteries, but probably will not fit it in the first instance. 

It weighs 43kg total. 33kg for the outside section and 9.5kw for the inside.

Cheers,

Peter



__________________

OKA196 DIY, self contained 4WD MH, 1160W PV, 326Ah of CALB LiFePO4 batteries, 1.3kW inv, 310L water, 350-450L diesel.



Guru

Status: Offline
Posts: 7579
Date:

I'm personally a Daikin buyer for decades. Actually getting another one to replace a reverse cycle portable.

 

But as far a Mitsubishi, my neighbour, who is a Mitsubishi fanatic, thinks the standard Mitsubishi is better than the heavy industries model. This year he installed one. It is amazing how quiet these new systems are.

 

At the end of the day any of the top quality 2.5kW models you can't go wrong with. The efficiency of the 2.5kW split systems will leave all other set-ups in their wake.



__________________

Procrastination, mankind's greatest labour saving device!

50L custom fuel rack 6x20W 100/20mppt 4x26Ah gel 28L super insulated fridge TPMS 3 ARB compressors heatsink fan cooled 4L tank aftercooler Air/water OCD cleaning 4 stage car acoustic insulation.

Page 1 of 1  sorted by
 
Quick Reply

Please log in to post quick replies.

Tweet this page Post to Digg Post to Del.icio.us
Purchase Grey Nomad bumper stickers Read our daily column, the Nomad News The Grey Nomad's Guidebook