Hi all, just a question about my cruiser caravan, I am thinking about buying a rhinoflex sewer hose made by camco in america, and was wondering if anyone on here has had any experience with them and whether they fit our dunp point inlets out here, thanks everyone.
Hi,Dougwe, no I didnt work in local government at all over this way, was a train conductor for a few years in the cobram area though.As far as the hose goes I am after one that fits the american cruiser van I have,which the rhino does,but wasnt sure if it would be ok for our dump points...checked out the wodonga point and it looks big enough to accomodate it.Thanks for the welcome and hope to see you on here in the future.
All the Blue Lid Dumpezy dumpoints are 150mm in Diameter at the top then reduce to 100mm in most instances. I have installed a quite a few of them . Cheers Mick
Hi all, just a question about my cruiser caravan, I am thinking about buying a rhinoflex sewer hose made by camco in america, and was wondering if anyone on here has had any experience with them and whether they fit our dunp point inlets out here, thanks everyone.
Hi Peter,
Bit of a two edged sword these hose system unless your set up is a pump as well.
I mean I have seen dump points in out of the way places designed just for cassettes. They were mounted on a wall and 800 mm off the ground. (Kangaroo Valley NSW). How a hose gravity feed will work on that I don't know.
As far as a hose being good or not, as long as it has the same snap connector as yours, no problem.
Not a lot of glory in the task though as many dump points have at least a 150 mm step.
I once saw a bloke disconnect from his van thinking the job was done. He didn't realise how heavy the remainder of the full pipe was.
Most amusing, but not for the victim. No gloves on and he dropped his end causing a spill......Then he grabbed it and lifted it up to regain control. The thing then came out of the dump point end and spilled every where.
