I have had a few occassions where I got caught out not having a Hiflo diesel inlet on my Colorado so made this up and it actually works well.
I got the appropriate size piece of rubber tube to fit the Hiflo gun at the servo and another smaller piece to fit the Collie. I then got the soldering iron heated up and welded the two sections together then a covering of silicone around the outside of the join for double seal. I got the pieces of tube in the irrigation section of the big green shed.
The hose clamp is to make for a tight fit on the servo gun.
You MUST adjust the flo rate yourself though and can take a little time BUT gets you out of trouble.
Just as a little something else. I carry a box of disposable gloves on the floor inside the Collie for when I am filling up with diesel, saves the smelly hands after.
I think the bit that goes in the Collie could be longer but that's the length available at time. I will improve on the adaptor when I need to replace it.
I just got a couple of different sizes at first and tried at the local servo before I made it up.
__________________
Live Life On Your Terms
DOUGChief One Feather (Losing feathers with age)
TUG.......2014 Holden LT Colorado Twin Cab Ute with Canopy
DEN....... 2014 "Chief" Arrow CV (with some changes)
You can get silicone reducers pre made too. 35mm to 25mm silicone reducer Might be a handy alternative just in case the lower tube fell out and jammed in the filler pipe. A few years back I had that problem happen to me when filling a Mirage aircraft with fuel on the tarmac in Bali. The filler tube separated from the refuelling gun and fell into one of the fuel tanks. We had no way or getting it out where we were, so the aeroplane flew back with the 10" of steel tube inside the tank.
__________________
Yes I am an agent of Satan, but my duties are largely ceremonial.
I got one of the reducer's you put the link up for Troopy BUT it doesn't fit the gun or tug, bugga. Worth a try though.
I sent a note to the supplier and he said it is not made for that so wouldn't do anything. It is actually to fit between two different size hoses/pipes.
Worth a try.
__________________
Live Life On Your Terms
DOUGChief One Feather (Losing feathers with age)
TUG.......2014 Holden LT Colorado Twin Cab Ute with Canopy
DEN....... 2014 "Chief" Arrow CV (with some changes)
I got one of the reducer's you put the link up for Troopy BUT it doesn't fit the gun or tug, bugga. Worth a try though.
I sent a note to the supplier and he said it is not made for that so wouldn't do anything. It is actually to fit between two different size hoses/pipes.
Worth a try.
That's a bit of a bugger Doug. It looked like it would be a good solution too. Hope you find a use for it. You may have to get some different sized pipes so you can join them together with it
__________________
Yes I am an agent of Satan, but my duties are largely ceremonial.