check out the new remote control Jockey Wheel SmartBar Canegrowers rearview170 Cobb Grill Skid Row Recovery Gear Caravan Industry Association of Australia
Members Login
Username 
 
Password 
    Remember Me  
Post Info TOPIC: air conditioning and heating?


Guru

Status: Offline
Posts: 3332
Date:
air conditioning and heating?


can a motor home heater/conditioner be run from

solar power ? or are they more suited for generators?

ie in a motor home situation



__________________

The Drewsterz my band site

Milo Online  my personal site

Love what you do  Do what you Love!!   my motto in life !

 



Guru

Status: Offline
Posts: 865
Date:

Hi Milo, 

I have been researching this topic for a long time, and am convinced it is possible to run a reverse cycle air conditioner from an invertor, however the roof top RV units are not very well suited as they are old style non inverter units.

The roof top RV units I am aware of control the temperature by running the compressor until the temperature drops, then stopping the compressor (fans keep running), then when the temperature rises again they repeat the cycle. The motors only run at one speed (controlled by mains frequency), and are typically hard to start. As an example the Air Command Ibis that I am optioning out of my caravan has a running current of 5.9A, and a quoted starting current of 20 amps. At this sort of drain it would need a huge inverter, and battery to run it.

I am going to run a Fujitsu Split system with inverter drive. What the inverter means here is that the incoming 240V power is rectified to DC, then inverted back to AC but at the frequency the motor needs to run at to maintain the required temperature. Yes it means the motor basically runs all the time but often at a very low speed, and with a very low current drain. It also means the motor can be started gradually, thus reducing the current required to start it. The unit I am going to run requires 2.8A running current, with a maximum current requirement of 6A.

I will be feeding my unit from a low frequency pure sine wave inverter. It is important that it is low frequency as they have a physical transformer, and can handle much higher overloads for longer periods, this means you can reduce the basic size of the inverter. I will be feeding my inverter with DC from a large lithium battery, which I will charge using a number of light weight solar panels glued to the roof.

I hope this vastly simplified explanation helps.



__________________

 

Discovery 4, 

Retreat Brampton

 



Senior Member

Status: Offline
Posts: 304
Date:

G'day Milo, I'm running a Heron 3.0 (in wall) older type from a 3kw inverter from a 24 volt system (4x 12 volt batteries.)   I have found that it drags power at start up (as was mentioned by Plendo) which almost left me red faced when the truck motor only just turned over  when trying to drive off.   I now run it off either mains or a modified wave generator (pure sine wave is better).   Mine is a pre Y2K unit which may/may not make a difference.   Collyn RIVERS has a website (and a couple of books) on this type of subject.   From memory, go to Google (or similar) and type in Collyn Rivers Articles.  Hope this helps.

For what it's worth. 



__________________
Page 1 of 1  sorted by
 
Quick Reply

Please log in to post quick replies.

Tweet this page Post to Digg Post to Del.icio.us
Purchase Grey Nomad bumper stickers Read our daily column, the Nomad News The Grey Nomad's Guidebook